light 3, 6,7,8 turns on with continual beeping on 'power on at wall'. Hold pause brings up 'lid locked' .
Singh March 2016 |
2 4 &7 flashing, continual beeping on 'power on at wall'. Hold pause brings up 'lid locked' .
Paul December 2015 |
first light off and second light flashing when turned on
darryll October 2014 |
Yes. Error code 130. machine will begin cycle then fail at the spin/rinse setting. the error will / can graduate to just stopping the machine working at all. Lights 1 and 7 flash similtaniously every second with a beep.= error code 130.
the RPS can be accessed by removing the plastic cover ( the outer part of the motor ) by one bolt. remove cover to access the windings of the motor. Undo the four bolts , drop the windings off the machine. you now have two parts of the motor off and the RPS can be accessed. Remove, clean up or replace.
recomend an authorised F&P repair guy as they know the machines inside and out and are excellent.
Spin April 2010 |
Error code 130 is Rotor Position Sensor fault. The RPS is a small circuit board mounted down below on the side of the motor stator which tells the controller the position of the motor. It may be corroded & can be cleaned up & got working again but usually it needs replacing.
Lincoln Appliance NZ August 2009 |